6 CRR-NY 220-1.7NY-CRR

STATE COMPILATION OF CODES, RULES AND REGULATIONS OF THE STATE OF NEW YORK
TITLE 6. DEPARTMENT OF ENVIRONMENTAL CONSERVATION
CHAPTER III. AIR RESOURCES
SUBCHAPTER A. PREVENTION AND CONTROL OF AIR CONTAMINATION AND AIR POLLUTION
PART 220. PORTLAND CEMENT PLANTS AND GLASS PLANTS
SUBPART 220-1. PORTLAND CEMENT PLANTS
6 CRR-NY 220-1.7
6 CRR-NY 220-1.7
220-1.7 Source monitoring, recordkeeping and reporting.
(a) The owner or operator of a portland cement kiln or clinker cooler must maintain a file of daily clinker production rates, kiln feed rates, and any particulate emission measurements. The production and feed rates must be summarized monthly. The records and summary must be retained for at least five years following the date of such records and summaries and must be made available for inspection by the department during normal business hours.
(b) The owner or operator of a portland cement kiln at a dry process plant or clinker cooler at either a dry or wet process plant, subject to section 220-1.4(a) or (b) of this Subpart, must install, maintain, calibrate daily, and operate a device, approved by the department, for continuously measuring and recording the opacity of emissions from such kiln or clinker cooler. If two or more kilns are vented through a single stack, an opacity monitor in the common stack would satisfy the requirements of this subdivision. Records of opacity must be retained for at least five years following the date on which they are made.
(c) The owner or operator of a portland cement kiln shall demonstrate compliance with the NOx RACT emission limit(s) established in section 220-1.6(b) of this Subpart by measuring NOx emissions with a continuous emissions monitoring system (CEMS). The CEMS shall comply with the requirements of subdivision (d) of this section or with equivalent requirements approved by the department. Any approved equivalent CEMS requirements will be submitted by the department to the United States Environmental Protection Agency for approval as separate State Implementation Plan revisions.
(d) CEMS requirements.
(1) The owner or operator of a portland cement kiln shall install, calibrate, evaluate, operate, and maintain a CEMS, in accordance with the provisions of 40 CFR part 75, for measuring NOx at locations approved in the CEMS certification protocol under paragraph (3) of this subdivision, and shall record the output of the system.
(2) As part of its application for a permit or permit modification, the owner or operator of a portland cement kiln shall submit for department approval a CEMS monitoring plan that complies with the provisions of 40 CFR part 75, subpart F.
(3) The owner or operator of a portland cement kiln shall submit for department approval a CEMS certification protocol at least 60 days prior to CEMS certification testing. The certification protocol shall include the location of and specifications for each instrument or device, as well as procedures for calibration, operation, data evaluation, and data reporting.
(4) The procedures in subparagraphs (i) through (v) of this paragraph shall be used for determining compliance with the NOx RACT emission limit established under section 220-1.6(b) of this Subpart.
(i) The owner or operator of a portland cement kiln shall determine compliance daily on a 30 day rolling average basis. The 30 day rolling averages shall be calculated by dividing 30 day total NOx emissions by 30 day total clinker production. Only days when the kiln operates shall be included in the 30 day rolling averages.
(ii) Along with any specific additional data requirements mandated by the department for a particular portland cement kiln, annual re-certifications, quarterly accuracy, and daily calibration drift tests shall be performed in accordance with 40 CFR part 75, subpart C.
(iii) When NOx emissions data are not obtained because of CEMS downtime, or for periods when no valid CEMS data is available, the owner or operator of a portland cement kiln shall use 40 CFR part 75, subpart D, data substitution procedures.
(5) In addition to the requirements of subparagraphs (i) through (iii) of this paragraph, the owner or operator of a portland cement kiln shall comply with the CEMS recordkeeping and reporting requirements of 40 CFR part 75, subparts F and G.
(i) The owner or operator of a portland cement kiln shall notify the department of the planned initial start-up date of any new CEMS.
(ii) Emissions, monitoring, and operating parameter records or measurements required by this Subpart and any additional parameters required by the department shall be maintained for at least five years and made available to the department upon request.
(iii) On a semi-annual basis, the owner or operator of a portland cement kiln shall tabulate and summarize applicable emissions, monitoring, and operating parameter measurements recorded during the preceding six months, and submit these records to the department. These records shall be submitted in a format acceptable to the department and shall include:
(a) the 30 day rolling average NOx emissions as specified under paragraph (4) of this subdivision;
(b) identification of the operating hours when NOx emissions data are not included in a calculation of the 30 day rolling average emissions and the reasons for not including that data;
(c) a comparison of the NOx emissions to the NOx RACT emissions limit(s);
(d) type and amount of fuel burned on a daily basis and the as burned heat content of the fuel;
(e) the total daily NOx emissions and total daily clinker production; and
(f) the results of CEMS accuracy assessments as required by 40 CFR part 75, appendix A and B and any additional data quality information required by the department.
(e) Protocols, reports, summaries, schedules, and any other information required to be submitted to the department under provisions of this Subpart must be sent (in either hardcopy or electronically) as follows:
(1) one copy to the Division of Air Resources, New York State Department of Environmental Conservation, 625 Broadway, Albany, New York 12233; and
(2) one copy to the regional air pollution control engineer at the appropriate regional office of the department.
6 CRR-NY 220-1.7
Current through December 31, 2021
End of Document