17 CRR-NY 2D.29NY-CRR
STATE COMPILATION OF CODES, RULES AND REGULATIONS OF THE STATE OF NEW YORK
TITLE 17. DEPARTMENT OF TRANSPORTATION
CHAPTER V. NEW YORK STATE SUPPLEMENT TO THE NATIONAL MANUAL ON UNIFORM TRAFFIC CONTROL DEVICES FOR STREETS AND HIGHWAYS—2009 EDITION
PART 2. SIGNS
CHAPTER 2D. GUIDE SIGNS — CONVENTIONAL ROADS
17 CRR-NY 2D.29
17 CRR-NY 2D.29
2D.29 Route Sign Assemblies
INSERT the following paragraphs:
Guidance:
05A When a highway carries two or more routes, the route sign combinations in the assemblies should be arranged to present a symmetrical and balanced appearance to enable motorists to readily identify the route they desire to follow. Each combination should stand out as a separate unit.
05B Route sign combinations in Junction, Advance Route Turn, and Directional assemblies should preferably be mounted side by side rather than one above the other. However, there should generally be no more than three route sign combinations in the same horizontal row. Confirming and Reassurance assemblies should preferably display route sign combinations one above the other rather than side by side.
Option:
08A Junction, Advance Route Turn and Directional assemblies may be installed overhead on the approaches to intersections (see Section 2A.17).
Support:
09A Figure 2D-101 shows typical types of Route Sign assemblies.
17 CRR-NY 2D.29
Current through December 15, 2022
| End of Document |
IMPORTANT NOTE REGARDING CONTENT CURRENCY: JULY 31, 2023, is the date of the most recently produced official NYCRR supplement covering this rule section. For later updates to this section, if any, please: consult editions of the NYS Register published after this date; or contact the NYS Department of State Division of Admisnistrative Rules at [email protected]. See Help for additional information on the currency of this unofficial version of the NYS Rules.