12 CRR-NY 43.19NY-CRR

STATE COMPILATION OF CODES, RULES AND REGULATIONS OF THE STATE OF NEW YORK
TITLE 12. DEPARTMENT OF LABOR
CHAPTER I. INDUSTRIAL BOARD OF APPEALS
SUBCHAPTER A. THE INDUSTRIAL CODE
PART 43. COIN-OPERATED MACHINES
12 CRR-NY 43.19
12 CRR-NY 43.19
43.19 Plastic injection molding machines.
Plastic injection molding machines shall have complete and substantial enclosures for all electrical, mechanical, heating, hydraulic and pneumatic systems and shall not expose to contact any object so hot as to cause injury.
12 CRR-NY 43.19
Current through March 15, 2022
End of Document

IMPORTANT NOTE REGARDING CONTENT CURRENCY: The "Current through" date indicated immediately above is the date of the most recently produced official NYCRR supplement covering this rule section. For later updates to this section, if any, please: consult editions of the NYS Register published after this date; or contact the NYS Department of State Division of Administrative Rules at [email protected]. See Help for additional information on the currency of this unofficial version of NYS Rules.