12 CRR-NY 14-10.11NY-CRR
STATE COMPILATION OF CODES, RULES AND REGULATIONS OF THE STATE OF NEW YORK
TITLE 12. DEPARTMENT OF LABOR
CHAPTER I. INDUSTRIAL BOARD OF APPEALS
SUBCHAPTER A. THE INDUSTRIAL CODE
PART 14. CONSTRUCTION, INSTALLATION, INSPECTION AND MAINTENANCE OF HIGH PRESSURE BOILERS; CONSTRUCTION OF UNFIRED PRESSURE VESSELS
SUBPART 14-10. POWER BOILERS: EXISTING INSTALLATIONS
STRENGTH OF MATERIALS
12 CRR-NY 14-10.11
12 CRR-NY 14-10.11
14-10.11 Rivets.
When the diameter of the rivet holes in the longitudinal joints of a boiler is not known, the diameter and cross-sectional area of rivets, after driving, may be ascertained from Table X-1, or by cutting out one or more rivets in the body of the joint.
Table X-1
Sizes of Rivets Based on Plate Thickness
Thickness of plate | 1/4″ | 9/32″ | 5/16″ | 11/32″ | 3/8″ | 13/32″ |
Diameter of rivet after driving | 11/16″ | 11/16″ | 3/4″ | 3/4″ | 13/16″ | 13/16″ |
Thickness of plate | 7/16″ | 15/32″ | 1/2″ | 9/16″ | 5/8″ | . . . |
Diameter of rivet after driving | 15/16″ | 15/16″ | 15/16″ | 1-1/16″ | 1-1/16″ | . . . |
12 CRR-NY 14-10.11
Current through March 15, 2022
| End of Document |
IMPORTANT NOTE REGARDING CONTENT CURRENCY: The "Current through" date indicated immediately above is the date of the most recently produced official NYCRR supplement covering this rule section. For later updates to this section, if any, please: consult editions of the NYS Register published after this date; or contact the NYS Department of State Division of Administrative Rules at [email protected]. See Help for additional information on the currency of this unofficial version of NYS Rules.