12 CRR-NY 14-10.6NY-CRR
STATE COMPILATION OF CODES, RULES AND REGULATIONS OF THE STATE OF NEW YORK
TITLE 12. DEPARTMENT OF LABOR
CHAPTER I. INDUSTRIAL BOARD OF APPEALS
SUBCHAPTER A. THE INDUSTRIAL CODE
PART 14. CONSTRUCTION, INSTALLATION, INSPECTION AND MAINTENANCE OF HIGH PRESSURE BOILERS; CONSTRUCTION OF UNFIRED PRESSURE VESSELS
SUBPART 14-10. POWER BOILERS: EXISTING INSTALLATIONS
MAXIMUM ALLOWABLE WORKING PRESSURE
12 CRR-NY 14-10.6
12 CRR-NY 14-10.6
14-10.6 Steam heating boilers.
Where a pressure of more than 15 pounds is found on a boiler for which exemption is claimed under the provisions of section 204 of the Labor Law or where a low pressure insurance policy is in force on such a boiler, the commissioner may order a safety valve or valves of the low pressure spring pop type, which cannot be adjusted for a greater pressure than 15 pounds attached to the boiler and shall also order a low pressure steam gage graduated to not over 30 pounds.
12 CRR-NY 14-10.6
Current through March 15, 2022
| End of Document |
IMPORTANT NOTE REGARDING CONTENT CURRENCY: The "Current through" date indicated immediately above is the date of the most recently produced official NYCRR supplement covering this rule section. For later updates to this section, if any, please: consult editions of the NYS Register published after this date; or contact the NYS Department of State Division of Administrative Rules at [email protected]. See Help for additional information on the currency of this unofficial version of NYS Rules.