9 CRR-NY 312.4NY-CRR
9 CRR-NY 312.4
9 CRR-NY 312.4
312.4 Industry standards.
When installing new or replacement permanent outdoor lighting fixtures, State agencies shall comply with the following industry standards contained within the following publications:
(a) Roadway lighting: Any of the industry standards listed in paragraph (1), (2), or (3) of this subdivision may be used provided the standard contains a guideline for the relevant type of roadway lighting application.
(1) American Association of State Highway and Transportation Officials (AASHTO) – Roadway Lighting Design Guide 6th ed. (October 2005).
(2) Approved American National Standards Institute (ANSI)/Illuminating Engineering Society (IES) – RP-8-14 Roadway Lighting.
(3) IES – DG-19-08 Design Guide for Roundabout Lighting.
(b) Parking-lot lighting: IES – RP-20-14 Lighting for Parking Facilities.
(c) Building facade lighting: IES – The Lighting Handbook, 10th Edition.
(d) Building-mounted fixtures not specifically intended for roadway lighting, parking-lot lighting or building facade lighting: The Lighting Handbook, 10th Edition.
Whenever a State agency uses any of the IES standards identified in this section, such agency shall also refer to The Lighting Handbook, 10th Edition in order to properly interpret such IES standards.
9 CRR-NY 312.4
Current through September 15, 2021
| End of Document |
IMPORTANT NOTE REGARDING CONTENT CURRENCY: The "Current through" date indicated immediately above is the date of the most recently produced official NYCRR supplement covering this rule section. For later updates to this section, if any, please: consult editions of the NYS Register published after this date; or contact the NYS Department of State Division of Administrative Rules at [email protected]. See Help for additional information on the currency of this unofficial version of NYS Rules.