Home Table of Contents

§ 12-405. Labeling of safety glazing material

West's Annotated Code of MarylandPublic Safety

West's Annotated Code of Maryland
Public Safety (Refs & Annos)
Title 12. Building and Material Codes; Other Safety Provisions (Refs & Annos)
Subtitle 4. Safety Glazing (Refs & Annos)
MD Code, Public Safety, § 12-405
Formerly cited as MD CODE Art. 83B, § 6-302
§ 12-405. Labeling of safety glazing material
Currentness
Permanent labeling required
(a)(1) Except as provided in subsection (c) of this section, each light of safety glazing material manufactured, imported, or sold for use in a hazardous location or installed in a hazardous location in the State shall be permanently labeled by etching, sandblasting, firing of ceramic material, hot-die stamping, or other means.
(2) The label shall be legible and visible after installation.
Contents
(b) The label shall:
(1) identify the labeler;
(2) identify whether the labeler is a manufacturer, fabricator, or installer;
(3) identify the nominal thickness and type of safety glazing material; and
(4) state that the safety glazing material meets the test requirements of the ANSI Standard.
Exception
(c) Wire glass, laminated glass, or rigid plastic that is further fabricated after manufacture need not be permanently labeled if the seller or installer of the material gives each buyer of the material a certificate that states that the wire glass, laminated glass, or rigid plastic meets the test requirements of the ANSI Standard.
Labeling on other material prohibited
(d) Safety glazing labeling may not be used on material other than safety glazing material.

Credits

Added by Acts 2003, c. 5, § 2, eff. Oct. 1, 2003.
MD Code, Public Safety, § 12-405, MD PUBLIC SAFETY § 12-405
Current through legislation effective through May 9, 2024, from the 2024 Regular Session of the General Assembly. Some statute sections may be more current, see credits for details.
End of Document