Home Table of Contents

§ 2823. Design Requirements for Piping and Hoses.

23 CA ADC § 2823Barclays Official California Code of Regulations

Barclays California Code of Regulations
Title 23. Waters
Division 3. State Water Resources Control Board and Regional Water Quality Control Boards
Chapter 20. Standards for the Removal of Sewage from Vessels
Article 2. Design and Construction
23 CCR § 2823
§ 2823. Design Requirements for Piping and Hoses.
Currentness
All piping/hosing used in the design and construction of a pumpout system shall:
(a) Be designed to withstand any pumping pressure or vacuum encountered without leakage; and
(b) Be constructed of material capable of withstanding solar radiation and chemical action of freshwater, saltwater, chemical additives, and sewage without excessive deterioration.
All fittings shall be of corrosion-resistant material and shall be so constructed and installed as to ensure a water-tight seal. All pumpout systems shall be designed and constructed to have a minimum capability of pumping out vessel marine sanitation devices having 1 1/2-inch fittings. The system shall be designed and constructed to prevent leakage when transferring or when the system is disconnected. This would normally require a minimum of four valves; one on each side of the pump, plus one at the storage tank, and one at the vessel holding tank connection.

Credits

Note: Authority cited: Sections 775, 776, 777 and 778, Harbors and Navigation Code. Reference: Sections 775, 776, 777 and 778, Harbors and Navigation Code.
History
1. New Note filed 10-1-85; effective thirtieth day thereafter (Register 85, No. 40).
2. Editorial correction of printing error in subsection (b) (Register 94, No. 26).
This database is current through 6/21/24 Register 2024, No. 25.
Cal. Admin. Code tit. 23, § 2823, 23 CA ADC § 2823
End of Document