(a) For each Program 2 process, the owner or operator shall provide in the RMP the information indicated in sections (b) through (l). If the same information applies to more than one covered process, the owner or operator may provide the information only once, but shall indicate to which processes the information applies.
(b) The five- or six-digit NAICS code that most closely corresponds to the process.
(c) The name(s) of the chemical(s) covered.
(d) The date of the most recent review or revision of the safety information and a list of federal or state regulations or industry-specific design codes and standards used to demonstrate compliance with the safety information requirement.
(e) The date of completion of the most recent hazard review or update.
(1) The expected date of completion of any changes resulting from the hazard review;
(2) Major hazards identified;
(3) Process controls in use;
(4) Mitigation systems in use;
(5) Monitoring and detection systems in use; and,
(6) Changes since the last hazard review.
(f) The date of the most recent review or revision of operating procedures.
(g) The date of the most recent review or revision of training programs;
(1) The type of training provided -- classroom, classroom plus on the job, on the job; and,
(2) The type of competency testing used.
(h) The date of the most recent review or revision of maintenance procedures and the date of the most recent equipment inspection or test and the equipment inspected or tested.
(i) The date of the most recent compliance audit and the expected date of completion of any changes resulting from the compliance audit.
(j) The date of the most recent incident investigation and the expected date of completion of any changes resulting from the investigation.
(k) The date of the most recent change that triggered a review or revision of safety information, the hazard review, operating or maintenance procedures, or training.
(l) The owner or operator shall submit the following external events analysis information:
(1) The types of natural and human caused external events considered in PHA Section 5100.2 or Hazard Review Section 5090.2.
(2) The estimated magnitude or scope of external events which were considered. If not known, the owner or operator of the stationary source shall work closely with the UPA to determine what is required. If seismic events are applicable, the parameters used in the consideration of the seismic analysis and which edition of the Building Code was used when the process was designed.
(3) For each external event, with a potential to create a release of a regulated substance that will reach an endpoint offsite, apply sections (e)(1) through (e)(6).
(4) The date of the most recent field verification that equipment is installed and maintained as designed.
Credits
Note: Authority cited: Sections 25531 and 25534.05, Health and Safety Code. Reference: Section 25531, Health and Safety Code; and Section 68.170, Part 68, Title 40, Code of Federal Regulations.
History
1. Change without regulatory effect renumbering section 2745.6 to new section 5070.6, including amendment of subsection (l)(1), filed 3-6-2024 (Register 2024, No. 10).
This database is current through 5/10/24 Register 2024, No. 19.
