Home Table of Contents

§ 1206. Federal Regulations.

25 CA ADC § 1206BARCLAYS OFFICIAL CALIFORNIA CODE OF REGULATIONS

Barclays Official California Code of Regulations Currentness
Title 25. Housing and Community Development
Division 1. Housing and Community Development
Chapter 2. Mobilehome Parks and Installations
Article 4. Fuel Gas and Oil Requirements
25 CCR § 1206
§ 1206. Federal Regulations.
A park gas piping distribution system is subject to the Pipeline Safety Law of 1994 (49 USC Section 1971) and regulations adopted by the Office of Pipeline Safety Operations. The applicable regulations are contained in Title 49 of the Code of Federal Regulations, Parts 191 and 192.
(a) The operator of a park gas piping system is responsible for complying with the federal regulations in addition to this chapter. A permit is not required from the enforcement agency for the installation of cathodic protection if the existing gas piping system is not otherwise altered.
This chapter does not prohibit the installation of cathodic protection systems and requirements for corrosion control of buried or submerged metallic gas piping systems required by the federal regulations in existing systems. If there is any conflict between the provisions of this chapter and the federal regulations, the provisions of the federal regulations shall prevail.
(b) Plans and specifications for the installation of a metallic gas piping system shall specify methods of protecting buried or submerged pipe from corrosion, including cathodic protection, unless it can be demonstrated that a corrosive environment does not exist in the area of installation. The design and installation of a cathodic protection system shall be carried out by, or under the direction of, a person qualified by experience and training in pipeline corrosion methods so that the cathodic protection system meets the requirements of Title 49 of the Code of Federal Regulations, Parts 191 and 192.
(1) All buried or submerged metallic gas piping shall be protected from corrosion by approved coatings or wrapping materials. All gas piping protective coatings shall be approved types, machine applied, and conform to recognized standards. Field wrapping shall provide equivalent protection and is restricted to those short sections and fittings necessarily stripped for threading or welding. Risers shall be coated or wrapped to a point at least six (6) inches above grade.
(2) All metallic gas piping systems shall be installed in accordance with plans and specifications approved by the enforcement agency, including provisions for cathodic protection. When the cathodic protection system is designed to protect only the gas piping system, the gas piping system shall be electrically isolated from all other underground metallic systems or installations. When a cathodic protection system is designed to provide all underground metallic systems and installations with protection against corrosion, all such systems and installations shall be electrically bonded together and protected as a whole.
(3) When non-metallic gas piping is installed underground, a locating tape or No. 18 AWG or larger copper tracer wire shall be installed with and attached to the underground piping for the purpose of locating the piping system. The locating tape or tracer wire shall terminate above grade at an accessible location at one or more ends of the piping system. Every portion of a plastic gas piping system consisting of metallic risers or fittings shall be cathodically protected against corrosion.
Note: Authority cited: Section 18300, Health and Safety Code. Reference: Section 18690, Health and Safety Code.
HISTORY
1. Amendment filed 7-6-2004; operative 7-6-2004 pursuant to Government Code section 11343.4 (Register 2004, No. 28).
This database is current through 7/29/22 Register 2022, No. 30
25 CCR § 1206, 25 CA ADC § 1206
End of Document