Home Table of Contents

§ 1468. Awning--Design and Construction.

25 CA ADC § 1468Barclays Official California Code of Regulations

Barclays California Code of Regulations
Title 25. Housing and Community Development
Division 1. Housing and Community Development
Chapter 2. Mobilehome Parks and Installations
Article 9. Accessory Buildings and Structures
25 CCR § 1468
§ 1468. Awning--Design and Construction.
(a) An awning and its structural parts, except cloth, canvas, or similar flexible materials, shall be designed, constructed, and erected to adequately support all dead loads plus a minimum vertical live load of ten (10) psf except that snow loads shall be used where snow loads exceed this minimum. Requirements for the design of awnings necessary to resist minimum horizontal wind pressure are contained in the California Residential Code.
(b) The following awnings shall be completely freestanding;
(1) awnings with a roof structure dead load weight of more than six (6) psf;
(2) awnings exceeding twelve (12) feet in width (projection) as measured from the wall of the MH-unit to the outer edge of the awning roof; and
(3) awnings required to be designed and constructed for live loads in excess of ten (10) psf.
(c) Flashing or sealing materials may be used to provide a weather seal between a freestanding awning and a unit. No separation is required between a freestanding awning and an attached awning located on the same lot.
(d) Notwithstanding the provisions of subsection (b), an awning installed in an area with a roof live load not to exceed 20 psf with a dead load not to exceed six and one-half (6 ½ ) psf may be attached to an MH-unit provided all of the following apply:
(1) the MH-unit was manufactured after September 15, 1971, and bears a department insignia of approval or a HUD label of approval; and
(2) it is provided with continuous perimeter support under the rim joist below the wall for the entire length of the awning or as a perimeter support system designed in accordance with the California Residential Code and
(3) it is secured to the sidewall, excluding eaves and overhangs.
(e) Awnings with a roof structure dead load weight of one (1) psf or less, do not require perimeter supports on the MH-unit wall at the point of attachment unless the MH-unit installation instructions require perimeter wall supports because of the additional load.
(f) All awnings on lots occupied by recreational vehicles shall be freestanding and shall not transmit any loads to the recreational vehicle except for cloth or canvas or similar flexible material.
(g) Combustible material used in awnings shall not be installed within three (3) feet of the lot line pursuant to section 1428 of this chapter. However, wooden support posts, installed in accordance with section 1428(h), may be located up to a lot line.

Credits

Note: Authority cited: Section 18300, Health and Safety Code. Reference: Section 18552, Health and Safety Code.
History
1. Amendment filed 7-6-2004; operative 7-6-2004 pursuant to Government Code section 11343.4 (Register 2004, No. 28).
2. Amendment of subsections (d), (d)(2) and (h) filed 7-22-2005; operative 7-22-2005 pursuant to Government Code section 11343.4 (Register 2005, No. 29).
3. Editorial correction of History 2 (Register 2005, No. 33).
4. Repealer of subsection (g) and subsection relettering filed 1-21-2009; operative 1-21-2009 pursuant to Government Code section 11343.4 (Register 2009, No. 4).
5. Amendment of subsections (a) and (d)(2) filed 2-18-2011; operative 2-18-2011 pursuant to Government Code section 11343.4 (Register 2011, No. 7).
This database is current through 5/10/24 Register 2024, No. 19.
Cal. Admin. Code tit. 25, § 1468, 25 CA ADC § 1468
End of Document