(a) Three (3) complete sets of plans and specifications shall be submitted for all work to be performed, if required by the enforcement agency.
(b) Plans and specifications submitted to the enforcement agency shall be of sufficient clarity to indicate the nature and extent of all work proposed and show in detail that the work will conform to the provisions of this chapter.
(c) When the design of the system requires an engineering analysis of structural parts, or methods of construction, the plans, specifications, and calculations shall be signed by an architect or engineer. At the time of submission, the engineer's stamp of approval must be current.
(d) Any deviation from the approved plans and specifications shall be approved by the designer, engineer, or architect and shall be submitted to the enforcement agency for approval.
(e) The enforcement agency may waive the requirement for plans and/or specifications when the proposed work is of a minor nature.
(f) Complete plans, specifications, calculations, and supporting data shall be submitted where the work proposed is not in conformity with or deviates from the provisions of this chapter.
(g) An approved set of plans and specifications and a copy of the permit to construct shall be kept on the job site until the enforcement agency has made a final inspection.
Credits
Note: Authority cited: Section 18300, Health and Safety Code. Reference: Section 18501, Health and Safety Code.
1. Amendment filed 7-6-2004; operative 7-6-2004 pursuant to Government Code section 11343.4 (Register 2004, No. 28).
2. Amendment of section heading and subsection (c), repealer of subsections (g)-(h)(2) and (k)-(k)-(4) and subsection relettering filed 2-19-2013; operative 4-1-2013 (Register 2013, No. 8).
This database is current through 5/10/24 Register 2024, No. 19.
Cal. Admin. Code tit. 25, § 1034, 25 CA ADC § 1034
